When an approver sends an inspection back for Redo, it stays in the Available tab with a "Redo" tag on its card. You open it and change all the redo points, then Seek for approval — because the redo came from an approver, it goes back for approval (there is no Pass option here).
Open the Inspect module and go to the Available tab. Select the project.
Find the redo EQC — its card shows a "Redo" tag on the top-right corner.
Tap the card to open it.
Change / answer all the redo points, one by one. (To review the other points, tap "Show all points".)
At the bottom, tap Seek for approval. Because the redo came from an approver, it must go back for approval — so only Seek for approval appears (there is no Pass). All redo points must be changed first.
Select the Team and the approver to notify, and tap Done.
If there's a next stage, tap "Go to EQC list" to head to the Available tab and continue.
Because a redo came from an approver — it must go back for approval. So only Seek for approval is available, not Pass.
In the Available tab — its card carries a "Redo" tag on the top-right corner. Tap the card to open it.
No — only the redo points need changing. To review the other points, tap "Show all points".
Because all the redo points must be changed first. Once every redo point is addressed, Seek for approval becomes available.
A Fail happens during inspection — depending on the stage you can Pass it or Seek for approval. A Redo is sent by an approver, so it can only be Sent for approval again (see 2.2.14 Re-inspect fail checklist).
Tap "Go to EQC list" — you'll go to the Available tab to continue.
A redo inspection stays in the Available tab with a "Redo" tag on its card.
Because it came from an approver, only Seek for approval is available — no Pass.
All redo points must be changed to enable Seek for approval.
"Show all points" reveals the other checkpoints.
Select the Team and approver to notify before tapping Done.
2.2.14 Re-inspect fail checklist
2.2.5 EQC list explanation - Available, Paused & Approval
2.2.6 How to "PASS" the Approved EQC to complete the stage?
2.2.13 digiQC Inspection Workflows
